SURFACE
PREPARATION:
The maximum performance of DURACOTE
T-846 can be achieved
only when the metal surfaces to be protected ar
e clean, dry, and free of rust, oil, and mill scale
MAXIM
recommends that the metal substrate temperature be 40 - 95
deg.F (5 - 35 deg.C) at the time of product application.
APPLICATION:
DURACOTE T-846 is formulated
to be used as supplied.
DO NOT THIN DURACOTE T-846.
Incorrect thinning will affect film build, dry time and
productperformance. MAXIM
recommends that the ambient and product temperature be
40 - 95 deg.F (5 -
35 deg.C) at time of application. Do
not apply heat; fire or explosion may result
DURACOTE T-846
can be applied by spray or dip.
REMOVAL:
DURACOTE T-846
can be removed with naphtha or harsh petroleum solvent.
CAUTION:
DURACOTE T-846
cures by solvent evaporation. Use
with adequate ventilation. Adequate
ventilation is required for cure and to ensure against formation of an
explosive atmosphere.
THE PARTIALLY CURED FILM SHOULD NOT BE EXPOSED TO IGNITION SOURCES SUCH
AS FLARES, FLAMES, SPARKS, EXCESSIVE HEAT OR TORCHES.
Refer to
Maxim's MSDS for additional handling and first aid information.
NOTE:
The addition of any product over or
under this coating is not recommended.
The use of additional coatings could result in chemical incompatibility, thus
adversely affecting the
performance
of this coating as stated in the lab data section. For any questions, or
information needed, please contact your MAXIM representative.
For additional information,
product samples, etc., please contact;
MAXIM
OIL & CHEMICAL COMPANY
Fort
Worth Texas
Metro
(817)
293-4645
DISCLAIMER
Information contained
herein is believed to be correct and reliable. However, Maxim
Petrochemical Corporation does not assume liability for it or for
recommendations of our representatives inasmuch as conditions and methods of use
are beyond our control. Further, we make no warranty, expressed or
implied, of any kind regarding those products or their use and purchaser assumes
all risks of use or handling either in accordance with directions or not
MANUFACTURER
DISCLAIMER
The information and
recommendations contained herein are, to the best of the knowledge and belief of
Maxim Petrochemical Corporation, accurate and reliable as of the date issued.
Maxim does not warrant or guarantee their reliability, and Maxim shall not be
liable for any loss or damage arising out of use thereof.
The information and
recommendations are for the user's consideration and examination.
Conditions of use are beyond Maxim's control and therefore users are responsible
to verify this data under their own operating conditions to determine whether
the product is suitable for their particular purposes and they assume all risk
of their use, handling, and disposal of the product(s). This information
relates only to the product(s) designated herein and does not relate to its use
in combination with any other material or in any other process.
